BRAYER BR4209, Instruction Manual

Page: 9 / 44

9 EN
USING THE VACUUM CLEANER
The dust bin (11) is equipped with the cyclonic filter (20)
which sieves out garbage and dust from the ingoing air,
and the inlet HEPA (19) filter fully retains the finest dust
particles.
Note: provide that the HEPA filter (19) is always clean,
because the overall performance of the vacuum cleaner
depends on it.
Attention!
Before switching on and using the vacuum cleaner,
make sure that the HEPA filter (19), the separator (20),
the dust bin (11) and the outlet filter (17) are installed
properly.
• Take the power plug and unwind the power cord to
the required length, connect the power plug to the
mains socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (16) to switch the vacuum
cleaner on.
• While cleaning, you can control the suction power
using the manual suction power control (6) on the
flexible hose handle (5) (pic. 3).
• After you finish cleaning, switch the vacuum cleaner
off by pressing the on/off button (16) and unplug it.
• To wind the power cord, press the button (14); keep a
hold of the winding cord with your hand.
• If you have to make a break during the cleaning,
switch the vacuum cleaner off by pressing the button
(16) and install the brush (1) to the brush storage
(15) (pic. 4).
ATTENTION!
Before changing the attachments or cleaning the
dust bin (11), switch the vacuum cleaner off by
pressing the on/off button (16) and unplug it.
CLEANING AND MAINTENANCE
Cleaning the dust bin (11)
• It is recommended to remove garbage and dust from
the dust bin (11) after every room cleaning.
• Switch the vacuum cleaner off by pressing the on/off
button (16) and unplug it.
• Holding the handle (12), press the lock (13) and
remove the dust bin (11) (pic. 5).
• Place the dust bin (11) over a garbage bin.
• Pull the lock (24) and open the lower lid (25) (pic. 6).
• Remove accumulated dust and garbage from dust
bin (11).
• Close the lid (25).
• Install the dust bin (11) back to its place and make
sure that the dust bin (11) is fixed properly.
Cleaning the HEPA filter (19) and the separator (20)
installed in the dust bin (11)
• Preliminarily remove dust and garbage from the dust
bin (11) as described above.