BRAYER BR1105, Instruction Manual

Page: 12 / 62

12 EN
more, hot water will be poured into the cup.
• Turn the steam supply control knob (9) « »
clockwise to the position «o» to switch the hot water
supply off.
Notes:
- if you need to stop the water supply, press the
button (20) « » again;
- you can set up the pump operation time (see the
chapter «ESPRESSO PORTION SETTING»).
WARMING THE DRINKS
You can warm up your drinks by putting the
cappuccinator pipe (10) without the tip (12) into the cup
with the drink.
• Switch the espresso machine on and wait until the
espresso machine is preheated and the buttons (18,
19, 20) illumination glows constantly.
• Press the steam supply button (19) « ».
• Put the cappuccinator pipe (10) without the tip (12)
into the cup with the drink you want to warm up.
Carefully turn the steam supply control knob (9) «
» counterclockwise.
• Close the steam supply by turning the knob (15) «
» clockwise until bumping «•».
• Switch the coffee maker off by pressing the on/
off button (17) «
», the buttons (17, 18, 19, 20)
illumination will go out.
TROUBLESHOOTING
Problem Cause Solution
Water leaks from
the bottom of the
coffee maker
The tray is full of
water.
Please, clean the tray.
The coffee
maker is
damaged.
Please, apply to the service
center for repairing the
coffee maker.
Water leaks from
the filter holder.
There is ground
coffee on the
filter.
Clean the filter edges from
ground coffee.
Ready coffee
has unpleasant
taste.
The coffee
maker was not
washed after
descaling.
Clean the coffee maker
from mineral scale and
wash it from the remaining
descaling agent.
Ground coffee
was stored in a
humid place for
a long time.
Please, use fresh ground
coffee. Keep unused
ground coffee in a hermetic
package in a dry cool place.
The unit cannot
be switched on
No voltage in the
mains socket.
The power plug
is not completely
inserted into the
socket.
Make sure that the mains
socket is properly operating.
Check whether the power
plug is completely inserted
into the socket.
Steam doesn’t
froth milk
The steam ready
indicator is
flashing.
You can use steam to froth
milk only after the indicator
starts glowing white.
The used cup
does not suit
for proper milk
frothing.
Use a tall and narrow cup.
You used
skimmed milk.
Use only whole milk with fat
content 4-6%.