SERIES 6A ELECTROPNEUMATIC POSITIONER
QUICK START GUIDE
4 of 12
© 2021 BRAY INTERNATIONAL, INC. ALL RIGHTS RESERVED. BRAY.COM The Information
contained herein shall not be copied, transferred, conveyed, or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International, Inc.
1.0
MOUNTING AND SETUP (Continued)
Step 5
Position the positioner on the actuator
and tighten the mounting screws.
Step 6
Insert the pneumatic fittings on the
positioner and actuator before inserting
tubing into the outputs of the positioner
to the inputs of the actuator.
Note:
Supply air will be routed to Y1 in
the event of a signal loss (fail condition.)
Single acting actuators release air from
Y1 upon loss of signal.
For double-acting actuators, make sure
Y1 is connected to the desired port for
fail position.
Step 7
Position the yellow ‘Transmission Ratio
Selector’ tab (2) in the 90° position by
pushing it away from the labeled side of
the device.
Step 8
Adjust the yellow clutch wheel (3) on the
underside of the terminals using a 4 mm
wide screwdriver to the 90° position.
2
3
