GB
version
1.0
E
Copyright Bravilor Bonamat B.V.
7
4.2
Daily use
D
Switch the machine on with the ON/OFF
switch (17.) behind the door (3.). When the
machine is on there is a little red square visible
on the switch. During warming up a flashing
thermometer appears in the upper right corner
of the display. Tapping is only possible after the
thermometer has disappeared from the display.
4.2.1
Tap cup
You can only select those drinks that are
indicated on the display by a black dot.
D
Place an empty cup under the Coffee outlet
(7.).
D
Select a drink with one of the selection buttons
(5.1 – 5.4).
– The selection made is confirmed with a
beep. On the display only the dot with the
selected drink remains after which the drink
flows into the cup. During the filling the cup
flashes on the display and the tapping cycle
is displayed by a circle building up with
segments.
4.2.2
Tapping mug, half a jug
or whole jug
TIP
– After
5
seconds the setting automatically
returns to tapping a cup.
– For
‘extra strong coffee’
it is
only
possible
to
tap
a cup (see for adjusting the settings
§6.2.2).
D
Select with the setting key (5.6 or 5.8) mug,
half a jug or whole jug.
TIP
– If a thermometer appears on the display the
temperature is (temporarily) too low caused
by tapping too much water. The machine is
blocked until the temperature is right again.
D
Place an empty mug or jug under the Coffee
outlet (7.).
D
Make a selection with one of the selection
buttons (5.1 – 5.4) for a drink.
– The selection made is confirmed with a
beep. On the display only the dot with the
selected drink remains after which the drink
flows into the mug or jug. During the filling
the cup flashes on the display and the
tapping cycle is displayed by a circle building
up with segments.
TIP
– By pressing any selection button after having
selected a mug, half a jug or a whole jug you
prevent the machine from really executing
this task. The machine is now limited to
tapping just one cup.
4.2.3
Indicator ‘drip–tray full’
The float indication (10.) will come up at reaching
the maximum level of spilled drink. In this case,
empty the drip–tray as soon as possible!
4.2.4
Raising the machine
When you use a mug or jug that
does not fit
under the drink outlet
you can temporarily
remove the drip–tray.
If necessary, the machine can be raised
2 cm
with a set of raising feet to increase the distance
between the drink outlets and the drip–tray. Such
a set can be ordered as accessory with your
specialist (§9.2.1).
