Brave PCLS1513, Owner'S Manual

Page: 32 / 48

Brave
32
800-350-8739
Troubleshooting
The following section details procedures for checking your log splitter, should you
encounter a malfunction. Brave recommends that you do not attempt to make repairs to
the log splitter. In the long run, it is better to take your log splitter to a servicing lawn and
garden dealer for repairs.
Problem: When the control handle is pushed forward (extend), the pusher plate does
not move.
1 . Check the hydraulic tank to make sure the oil level is correct.
2 . Remove the pump from the engine flange. Check the coupler, making sure
the drive keys are in place and there is no damage to the urethane spider.
3 . Disconnect the pusher plate from the cylinder. Grasp the hydraulic
cylinder shaft and try to pull it out. If the rod comes out easily, you will need
to rebuild or replace the cylinder.
4 . Once you have determined that the engine-to-pump coupler is intact and
the cylinder is in good condition, you will need to replace the pump.
Problem: The engine stalls when the pusher plate engages the wood.
1 . The engine may not be properly adjusted. Take the engine to a service
center for repair and/or adjustment.
2 . If all engine settings are correct, replace the pump.
Problem: The pusher plate moves slowly, but will split wood.
1 . Check the oil level in the hydraulic tank and fill if necessary.
2 . Check the high-pressure hose, fittings, and valve openings for dirt and
debris that may have obstructed the openings.
3 . If the ram speed is still slow, replace the pump.
Problem: The ram will not automatically retract.
1 . Check the slide rail or pusher plate for damage.
2 . Push the valve handle to the retract position. If the handle will not stay in
this position, contact the factory.