BRPRC110HE, REV B
10
REV 3/20
C.
STARTING ENGINE
WARNING:
Set parking brake on tow vehicle.
Attach mower tongue to tow vehicle.
WARNING:
Do not start rough cut mower unless it is attached to the tow vehicle.
Turn on the fuel shut off valve (red colored rotating knob) located inline on the fuel hose. The
off
position on the valve is when the red handle lines up with the “O” symbol.
Set the choke to the desired position.
Set the throttle at approximately half throttle.
Start engine and allow engine to warm up.
Set the engine speed at about half throttle and engage the mower blades clutch by pulling
outward on the PTO switch. (The PTO switch is located at the front of the mower deck on the
control panel.)
Note:
To help extend the life of the clutch the engine rpm should be placed as low as possible
before clutch engagement. If the engine should stall during clutch engagement raise
the engine rpm until clutch engagement is possible.
CAUTION:
If the mower’s engine dies while in use, remove the rough cut mower from the
uncut area before attempting to engage the clutch. Inspect the blades for any obstructions
that may prevent blade engagement. Failure to follow these instructions may result in
premature clutch and belt failure or a fire.
Adjust engine speed to full throttle.
D.
SHUTTING OFF ROUGH CUT MOWER
WARNING:
Shift to neutral and set the parking brake before dismounting the tow vehicle.
Slow the engine speed down and disengage the clutch by pushing inward on the PTO switch.
Allow engine to cool down for a short time before moving the ignition switch to the
off
position.
Turn off the fuel shut off valve (red colored rotating knob) located inline on the fuel hose. The
off
position on the valve is when the red handle lines up with the “O” symbol.
Summary of Contents for BRPRC110HEB
Page 19: ...BRPRC110HE REV B 19 REV 3 20 ...
Page 20: ...BRPRC110HE REV B 20 REV 3 20 ...