Braun VMAX-MIPI, User Manual

Page: 25 / 84

VMAX-MIPI User’s Manual 17 Ver 1.20
BARUN Technology
Corporation
http://www.baruntechnik.com
63 power.off all Set module power off all the VMAX-MIPI Non
64 gpio.link.level VMAX Terminal, I/O Buffer power voltage level 1
65 mipi.timing.lp LP Clock Timing control command 4
66 mipi.timing.data HS Data Timing control command 4
67 mipi.timing.clk HS Clk Timing control command 4
68 mipi.read.show Read MIPI module register data display. 6
69 mipi.read.show.set Read data display position, Font, set command 5
70 mipi.read.show.off Read data display disable command Non
71 mipi.read.iif Read MIPI module register data display function 2 9
72 SectionTRUE Compare routine start of mipi.read.iif read data 1
73 EndOfSectionTRUE Compare routine end of mipi.read.iif read data 1
74 SectionFALSE Compare routine start of mipi.read.iif read data 1
75 EndOfSectionFALSE Compare routine end of mipi.read.iif read data 1
76 beep Buzzer control on and beep sound 1
77 KeyOff.enable OFF Key press enable control Non
78 KeyOff.disable OFF Key press disable control. Non
79 KeyDown.enable DOWN/PREV Key press enable control Non
80 KeyUp.disable UP/NEXT Key press disable control Non
81 KeyDown.enable DOWN Key press enable control Non
82 KeyDown.disable DOWN Key press disable control Non
83 KeyDemo.enable DEMO Key press enable control Non
84 KeyDemo.disable DEMO Key press disable control Non
85 KeyF1.enable F1 Key press enable control Non
86 KeyF1.disable F1 Key press disable control Non
87 KeyF2.enable F2 Key press enable control Non
88 KeyF2.disable F2 Key press disable control Non
89 KeyF3.enable F3 Key press enable control Non
90 KeyF3.disable F3 Key press disable control Non
91 KeyF4.enable F4 Key press enable control Non
92 KeyF4.disable F4 Key press disable control Non
93 image Fill pattern <R0~255>, <G0~255>, <B0~255> Non
94 dvm.measure.set.1 power port1 output volt offset input command 1
95 dvm.measure.set.2 power port2 output volt offset input command 1
96 voutcalibration.1 power port1 output volt auto calibration command Non
97 voutcalibration.2 power port2 output volt auto calibration command Non
98 pwr.current.span.1 power port1 output current span offset command 1