Braun perfusor compact, Service Manual

Page: 24 / 86

Service Program
3
3 - 4 Perfusor® compact, 3.0 gb
Working with the Service Program
Preparation
1. Connect service cable ( Fig.: 3 - 3 / Item 2 ) to MFC connector
( Fig.: 3 - 3 / Item 1 ) of unit and to PC serial port (COM 1 or
COM 2).
2. Connect mains power cable to the unit.
3. Start the Service Program on the PC.
4. [Version 5.5004]: To start communication, press the ON key
on the Perfusor® compact until "Release On/Off key" is
displayed on the PC.
and are displayed on the LC
display.
[Version 2.1.0.1]: To start communication, select menu item
File
➨
Connect
, then keep the On key on the Perfusor®
compact pressed until disappears from the LC display.
After connection has been established and are
displayed.
Display / Save the Unit Settings
1. Menu item
File
➨
Connect
.
2. Menu item
EEPROM
➨
Read
.
3. Menu item File
➨
Save .
4. [Version 5.5004]: Select menu item
Modi
➨
Modification
Data
and menu item
Syringe
➨
Syringe selection
or
Syringe
types
. Note down parameters prior to any modification (e.g.
new E-Module).
[Version 2.1.0.1]: Select menu item
Modification
➨
Modification data and menu item Syringes
➨
Syringe
selection
or
Syringe types
. Note down parameters prior to
any modification (e.g. new E-module) or print out with File
➨
Print .
Adjust Unit Settings
1. Menu item
File
➨
Connect
.
2. Menu item EEPROM
➨
Read .
3. Desired modifications / display, please see:
- Service
➨
Service Values [Version 5.5004] or
Processing
➨
Processing values [Version 2.1.0.1]
-
Modi
➨
Modification Data
[Version 5.5004] or
Modification
➨
Modification data
[Version 2.1.0.1]
- Calibration
➨
Pressure calibration (required in case of
bolus rate change)
Fig.: 3 - 3
Legend of fig. 3 - 3:
ItemDesignation
1 MFC connector on the unit
2 MFC service cable
2
1
3.0