Braun BF3248Y-2, Operator, Installation, Service Manual

Page: 26 / 46

Page 24
Perform all procedures listed in previous section also
1500
Cycles
continued
750
Cycles
MAINTENANCE and LUBRICATION
Clean and lubricate. Apply Light Oil - See
Lubrication Diagram
Apply Door-Ease. See Lubrication Diagram
Tighten, replace or correct as needed.
Correct as needed
Clean and remove debris or obstructions
,IGULIWVWRRIDVWDGMXVWDSSOLFDEOH'ULIW0LFUR -
switch Cam so drift begins at reduced height.
Correct as needed
Blow out with air compressor
Clean and lubricate. Apply Door-Ease
5HVHFXUHDGMXVWPLFURVZLWFKHVUHSODFHGDP -
aged parts or otherwise correct as needed.
Chains at gears and chain assist assemblies
Drive arm slot
Inspect drive arm pivot points (mounting
screws, nuts and bearings) for positive secure-
ment, wear or damage
Inspect drive arm slots for excessive wear or
damage
Clean ramp and ramp mounting area (ensure
no debris in area to obstruct stowing/stacking)
Cycle ramp and observe drift speed during
deploy and stow functions
Inspect ramp for wear, damage or any abnor-
mal condition.
5HPRYHVXEÁRRUSDQFRYHUDQGFOHDQGLUW
and other foreign debris
5HPRYHVXEÁRRUSDQFRYHUDQGOXEULFDWH
drive arm gear and cylinder gear rack
5HPRYHVXEÁRRUSDQFRYHUDQGLQVSHFW
‡3XPSPRXQWLQJEROWVIRUVHFXUHPHQWORRVH
or missing)
‡'ULYHDUPDQGJHDUUDFNZHOGPHQWWHHWK
IRUIRUHLJQREMHFWVZHDURUGDPDJHEHQW
deformed, misaligned), positive securement
and proper operation
‡*HDUUDFNZHOGPHQWSLQVHFXUHPHQW(FOLS
(loose or missing)
‡+\GUDXOLFF\OLQGHUKRVHVÀWWLQJVDQGFRQ -
nections for wear, damage or leaks
‡+DUQHVVFDEOHVZLUHVWHUPLQDOVDQGFRQ -
nections for securement or damage
‡5HOD\VIRUVHFXUHPHQWRUGDPDJH
‡0LFURVZLWFKHVDQGFDPVIRUVHFXUHPHQWDQG
DGMXVWPHQW
‡0LFURVZLWFKZLUHVDQGWHUPLQDOVIRUVHFXUH -
ment or damage