16
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
If the station selects one of the required cleaning programs, it will not start unless you
press the start button (4).
For best shaving results, we recommend cleaning after
each shave.
Each cleaning program consists of several cycles, where cleaning fluid is flushed
through the shaver head. Depending on your Clean&Renew Station model and/or
program selected, the cleaning time takes up to 16 minutes. Leave the shaver in the
station for drying. It takes several hours until remaining moisture evaporates depending
on the climatic conditions.
When the program is finished, the blue indicator will light up.
Stand-by mode
10 minutes after completing the charging or cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators of the Clean&Renew station turn off.
Shaver display
The shaver display (16) shows the charge status of the battery on the left, and the
hygiene status on the right. 6 dark segments are shown on each side when the battery
is fully charged and the shaver is hygienically clean.
Battery segments:
During charging or when using the shaver, the respective battery segment (16a) will
blink. When fully charged all 6 segments are shown. With decreasing charge the
segments gradually disappear.
Low charge indicator
The low charge indicator (16c) provided with a red frame blinks to indicate that the
battery is running low. The remaining battery capacity is sufficient for 2 to 3 shaves.
Hygiene segments:
All 6 hygiene segments (16b) will appear after the shaver has been cleaned in the
Clean&Renew station. When the shaver is being used, the hygiene segments will
gradually disappear. Once the shaver is returned to the station, the system will
automatically select the appropriate cleaning program and restore the segments to
maximum hygiene. Given that rinsing the shaver under tap water is not as hygienic as
the cleaning station, the hygiene segments will only restore themselves when the
shaver has been cleaned in the Clean&Renew station.
Charging information
•
A full charge will take about 1 hour and provides up to 50 minutes of cordless shaving
time. This may vary according to your beard growth and environmental temperature.
5-minute quick charge is sufficient for a shave.
90793897_7899cc7898cc7897cc_w&d_MN_S6-120.indd 16
90793897_7899cc7898cc7897cc_w&d_MN_S6-120.indd 16
10.02.16 09:20
10.02.16 09:20
CSS APPROVED Effective Date 7Mar2016 GMT - Printed 04Apr2016 Page 16 of 120
