Brasilia OPUS SUBLIMA, User Manual

Page: 18 / 28

Rev 0 - 09-2008 ENGLISH / 15
5.3 - COFFEE DELIVERY
1) Remove the filtre-holder from the group (A) and and throw
away the grounds by knocking the edge of the filtre-holder on
the bar of the coffee ground drawer.
We recommend not knocking the filtre-holder against an un -
protected surface, since this could damage it.
The small quantity of ground left, will not have a negative effect
on the coffee delivered.
2) Fill the filtre-holder with finally ground coffee by placing it
in its special position at the base of the grinder-dispenser (B)
and pulling the lever (C) once for a single dose and twice for
a double dose.
Warning: always remember to pull the grinder-dispenser lever
completely; then leave it to return to its resting position.
Make sure that the grinder-dispenser has enough ground cof-
fee in its container for at least one dose.
3) Once the filtre-holder for espresso coffee delivery is full,
press the ground coffee using the tamper.
Clean the edge of the portafilter to remove any ground coffee
in excess, in order to ensure that there is a perfect seal betwe-
en the filtre-holder and the machine.
In the event of a mixed use filtre, you can insert a coffee pod
instead of the ground coffee.
4) Attach the filtre-holder to the group, by turning it until it is
secure (D).
Do not tighten it too much, or the filtre-holder will be very hard
to remove once delivery is completed.
5) Once the filtre-holder has been attached correctly, place a
previously warmed cup (~40°C) under the spout.
In case of a double filtre-holder, use two cups.
6) Press the button (*) on the touch key pad, corresponding to
the desired drink to be delivered.
(*) CONTINUOUS DELIVERY:
In order to have a continuous delivery (non-dosed) proceed as
in points 1) ÷5) and press CONT (1).
Once the desired quantity has been reached in the cup, press
STOP (4).
Warning: if the continuous delivery is not stopped manually
with the STOP button within 120 seconds, the group is blocked
and the orange block LED will go on (4).
To put the machine back into operation, disconnect the power
for at least 5 seconds, before powering it on again.