pg 9
Maintenance and Care
• The burner heats up during operation. After the fire has been
extinguished the burner will still be hot. Please allow the burner
and cover to cool for at least 30 minutes before touching with
bare hands.
• Only clean the surface of the product after it has fully cooled down.
• Do not use abrasive cleaners, scrubbing powder or similar
cleaners on the burner, as they can cause damage.
• To avoid spilling, make sure there is no alcohol left in the burner
before cleaning.
• To clean, use a wet clean cloth. Use only water and a mild dish
detergent, if needed, or wipe with alcohol to remove tough
tarnish stains. You can also use the polish pad, rubbing with the
grain of the metal, to remove tarnish stains.
• Before reusing the burner, make sure that all parts have been
put back in the correct place.
• You may notice black soot on the burner or cover plate after
the first use. This is due to natural minerals in the new metal
coming to the surface upon heating for the first time. Clean this
using alcohol and a clean cloth.
Further Safety Instructions
• If alcohol is spilled on the burner, wipe it up immediately using a soft,
absorbent cloth. Wash the cloth out afterwards with clean water.
• Allow the burner to cool for at least 15 minutes before refueling.
• Never put alcohol into an open fire. Explosion hazard.
• Never try to extinguish the flame with water. Explosion hazard.
• For safety reasons, this burner can only use denatured alcohol.
• Do not use the product if it shows visible damage. If you see
damage caused by shipping please contact your dealer.
• Repairs to the burner can only be done by your dealer.
• Do not move the burner while it is burning.
Summary of Contents for XL Burner
Page 5: ...pg 5 Assembly Diagram...
