9
5.4.4 The product does not exceed the noise values specified in the annex 1 article
1.7.4.2 letter u of the MO No. 176/2008 of the Coll. of Laws (EP and RE
directive No. 2006/42/EC)
Note: Articles 5.4.2 and 5.4.3 apply to NEXP product design.
5.5 DATA ON PRODUCT
Every product is fitted with label with specified data as follows:
Standard design:
NEXP product design:
Manufacturer’s identification Manufacturer’s identification
Address of the manufacturer Address of the manufacturer
Type of product
Type of product
Lifting capacity
Lifting capacity
Serial number
Serial number
Year of production
Year of production
CE marking
CE marking
Symbol of protection type(I
IM2ExhIMb
for group I,
II2GExhIICT6Gb, II2DExhIIICT85°CDb
for group II)
6 INSTALLATION OF THE PRODUCT
CHECK PRIOR TO INSTALLATION
Prior to installation, check carefully whether the product is not damaged.
The NEXP product must be installed in such a way as to prevent creeping charges.
Charging mechanisms stronger than manual friction must be avoided at the
installation site.
A NEXP product when used in a mine or other environment where the product could
collide with falling, flying… objects (rock, stones…) must be protected to minimize the
likelihood of a collision (sufficiently dimensioned cover, …).
6.1 LOAD CARRYING STRUCTURE
Travelling (crane) track and related load carrying structure (parts of buildings, etc.),
destined for the product operation must be documented by the drawing and stress
analysis.
! WARNING
ALWAYS
make sure the travelling track and related load carrying structure are
firm enough to support the weight of the load and product. The installation shall not
be carried out onto the structure, where the carrying capacity cannot be verified.
ALWAYS
make sure the travelling track is plane.
ALWAYS
make sure the ends of the travelling track are equipped with firm stop
blocks.
ALWAYS
the user is responsible for the load carrying structure!
6.2 TRAVELLING (CRANE) TRACK
! CAUTION
Products can be installed onto girders with the angle of the lower flange up to 20% or
with a flat flange. The range of lower flange width (b) and minimum radius of the
travelling track curvature (R) for particular lifting capacities are mentioned in the
article 5.1 DIMENSIONS.