2
SPECIFICATIONS ___________________________________________________________
Min/Max Compressed Air Supply
100 to 175 psi (6.9 to 12.0 bar)
Dimensional data
13.06 x 20.88 x 48.75 in (33.2 x 53 x 123.8 cm)
Weight
120 lbs (54.4 kgs)
Specifications shown below are at an air temperature of 75° F (24° C) and a supply air pressure of 125psi (8.6
bar). These specifications are intended to be a baseline to result in the production of 95% pure Nitrogen. The
output flow of Nitrogen has been pre-set to 3.2 scfm (5.1 Nm³/hr) per membrane. Changes to air temperature,
supply air pressure or supply air flow will change the result of Nitrogen purity.
Model Supply Air Pressure
Supply Air Flow
Maximum
Output N
2
Flow
N
2
#
psi
bar
scfm
Nm³/hr
scfm
Nm³/hr
Purity
350
125
8.6
6.3
10.1
3.2
5.1
95%*
Change
Note
Result
When supply air temperature increases
Supply air flow requirement will increase
Nitrogen Purity
When supply air pressure increases
increases
When supply air flow decreases
N
2
output flow will decrease
When supply air temperature decreases
Nitrogen Purity
When supply air pressure decreases
decreases
When supply air flow increases
N
2
output flow will remain the same
Nitrogen Purity
stays the same
INTENDED USE _____________________________________________________________
The Nitrogen Inflation System is a pneumatic device designed to generate deoxygenated air for the purpose of
inflating vehicle tires.
CAUTION
Before using this product, read and fully understand the operating
instructions and all decals on the product. This is necessary to
prevent injury to the operator and damage to the product.
Do not attempt to use this product for anything other than its
intended purpose.
Use of this product should be in a suitably ventilated shop.
Operate valves slowly to prevent damage to coalescing filter.
Use of this product is only permitted in places free from explosion
or fire hazard.
Do not use this product if it is visibly worn, distorted or damaged.