55
G
AT A GLANCE
Preparation and start
1. Open water tap fully. Check to see
that all hoses are tight.
2. Place laundry in the drum.
3. Fill in detergent and fabric condition-
er.
4. Set the programme selector.
5. If desired:
– activate any additional function(s),
– set the spin speed,
– set a delayed start.
6. Press the »Start/Pause«
button
(except for delayed start).
In the display the end-of-programme
time is shown.
Changing a programme
1. Set the programme selector to »Stop«,
then wait approx. 2 seconds.
2. Set the programme selector to the
new programme.
3. Press the »Start/Pause«
button.
Aborting a programme
1. Set the programme selector to »Stop«,
then wait approx. 2 seconds.
2. Set the programme selector to »Spin/
Drain« .
3. Press the »Start/Pause«
button.
4. Wait for the programme cycle to end.
Adding more laundry
3
This is only possible during the time-
delay period.
1. Open the door and add laundry.
2. Close the door.
Programme halted by rinsehold
3
This condition is indicated by flashing
»Rinse & hold«
and
»Pause« indi-
cator lamps.
If you wish to
spin
:
1. Set the spin speed.
2. Press the »Rinse & hold«
button.
The programme is continued, pumps
out and spins.
If you wish to
pump out
only:
1. Set spin speed selector to »No spin« .
2. Press the »Rinse & hold«
button.
The programme is continued, only
pumping the water out.
Spinning the laundry again
3
The automatic spin-correction-system
can prevent the spinning if the drum is
out-of-balance.
If you wish to spin again:
1. Set the programme selector to »Stop«.
2. Open the door and rearrange the
laundry evenly in the drum.
3. Set the programme selector to »Spin/
Drain« .
4. Set the spin speed.
5. Press the »Start/Pause«
button.
After completion of the programme
cycle
3
When the programme sequence indi-
cator »Stop« goes on, the programme
is completed.
The display will then show the current
time again.
1. When the »Door locked«
indica-
tor lamp goes out, open the door and
remove the laundry.
2. Set the programme selector to »Stop«.
3. Close tap.
4. Wipe out the sealing fold of the rub-
ber collar; check sealing fold and
drum for foreign matter.
5. Leave door and detergent dispensing
drawer open for drying out.
