Brandt VS1010X, Instruction Manual

Page: 7 / 32

For detailed operating method read the co rresponding conte nt on the instruction manual.
With each wash cycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a program
Running the dishwasher
Fill the detergent dispenser
To lo ad the baske ts, ref er to t he sec tion en titled Pre paring and L oading Dishe s .
“ ”
Switch on the appliance
Switch off the appliance
Turn off the water tap,
unload the baskets
Warn ing: wait a f ew min utes (about 15 min utes) before unloa ding th e dish washe r to av oid
hand ling th e dish es and utens ils wh ile the y are s till hot and m ore su scepti ble to break.
The dishes will al so dry better. First start u nloading the lower baske t.
Changing the program
Adding forgotten dishes in
the dishwasher.
If the appliance is switched
off during a wash cycle.
Open the do or care fully.
Look o ut for hot ste am
when openin g the d oor!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause Button to stop washing , Then press programme button
the program will cancel.
3. Turn the selector to select a new program.
4. .Press the Start/Pause Button, the dishwasher will run after 10 seconds.
f
or 3 seconds and
1.Press the Start/Pause Button to stop the washing.
2.Open the door a little .
3.After the spray arms stop working, you can open the door completely.
4.Add forgotten dishes.
5.Close the door
6.Press the Start/Pause Button, the dishwasher will run after 10 seconds.
Turn on the water tap and press the Start/Pause Button. The machine will start working
after about 10 seconds.
Close the door, press the program button until the selected program indicator lights up.
( See the section entitled
Operation instruction )
“ ”
Press the On/Off button to switch on the appliance, Open the door.
When the working cycle has finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
Since the appliance in stand-by, it will power off automaticly after 30 minutes without any operation.