Brandt TK-K30PX, Instructions For Use Manual

Page: 9 / 14

8
• Make sure that the kettle lid is down and
the filter is intact when tipping the kettle
so that the boiling water does not come
out of the lid opening.
• Do not operate the kettle on a sloped surface
or move the kettle whilst it is working.
• Make sure that the water level is between
the minimum and maximum indicated on
the kettle.
• Do not fill the kettle whilst it is connected
to the connection base. If the connection
base is damp, disconnect the power,
remove the kettle and dry it properly.
Once it has dried, you can connect the
base again and put the kettle on its
connection base.
4. APPLIANCE OPERATION
Preparation
Before using it for the first time, clean and
rinse inside the kettle as shown in section "5.
Cleaning"
Remove the kettle from its packaging, check
inside and remove the packaging and the
wrapping.
Check that the lid and the filter are fitted
properly. If not, assemble it as shown in figure 3 .
Assembly
In order to switch the appliance on, it is necessary
to connect the kettle to a connection base. It can
be placed on a single connection base and in
your kitchen if you have a K-Station base for this
purpose.
The connection mechanism is the same in
both cases.
Connection to the single base: Fig 4
Connection to the K-Station:
Fig 5
The kettle can be used as soon as it is fitted
on the base properly.
Using the appliance
1.
Remove the appliance from its base to
fill it with water. You can remove the lid
as shown in
figure 6
to fill it more easily,
but you can also fill it with the lid open.
In order to open the lid
(A)
, press the lid
open button
(B) (Fig. 7)
Always keep the water level above
the minimum level and below the
maximum level marked inside the
kettle.
2.
Once the correct level of water has been
reached, close the lid
(A)
by pressing
the lower part until it fits hermetically
into place.
3.
Press the ‘on’ switch
(E)
as shown in
figure 8
. The blue switched on light
(F)
will come on whilst the appliance is
working.
4.
After boiling, the kettle will disconnect
automatically.
Device to stop the water overflowing
If you try to fill the kettle above the
maximum marked level, the overflow water
will come out through the base via a device
designed for this purpose.
In this case, before drying the water
which has come out of the opening in the
kettle base, disconnect it and remove the
appliance. Once this has been done, dry it
with a soft cloth.