Brandt DWF128DS, Instruction Manual

Page: 27 / 148

25
Spilled rinse-aid. Always wipe up rinse-aid spills
immediately.
Stained tub interior Detergent with
colourant may
have been used. Make sure that the detergent has no
colourant.
White film on
inside surface Hard water minerals. To clean the interior, use a damp
sponge with dishwasher detergent
and wear rubber gloves. Never use
any other cleaner than dishwasher
detergent otherwise, it may cause
foaming or suds.
There are rust
stains on cutlery The affected items
are not corrosion
resistant.
A program
was not run after
dishwasher salt was
added. Traces of
salt have gotten
into the wash cycle.
Always run a wash program
without any crockery after adding
salt. Do not select the Turbo function
(if present), after adding dishwasher
salt.
The lid of the softer
is loose. Check the softener lid is secure.
Problem Possible Causes What To Do
Avoid washing items that are not
corrosion resistant in the dishwasher.
Knocking noise in
the dishwasher A spray arm is knocking
against an item in a
basket Interrupt the program and
rearrange the items which are
obstructing the spray arm.
Rattling noise in
the dishwasher Items of crockery
are loose in the
dishwasher. Interrupt the program and
rearrange the items of crockery.
Knocking noise in
the water pipes This may be caused
by on-site installation
or the cross-section
of the piping. This has no influence on the
dishwasher function. If in doubt,
contact a qualified plumber.
The dishes
are not clean The dishes were not
loaded correctly. See PART
Ⅱ
“Preparing And Loading
Dishes”.
The program was
not powerful enough.
Select a more intensive program.