40
For your own safety, you must comply with the instructions given below.
The electrical installation must comply with Standard NF C *15-100, in particular concerning
the Earth.
Three-core flex 3x2.5 mm², 230V single-phase connected to:
- A 20A single-phase 230V-50Hz supply
- An ELCB and an individual fuse (10 or 16A depending on the model)
We cannot be held responsible for any incident caused by faulty electrical installation.
Recommendations for the electrical installation of your appliance:
- Do not use extension leads, adaptors, or socket strips.
- Always make sure your circuit is earthed.
- The socket must always remain accessible, yet be out of the reach of children.
If you have any doubts, contact your installer.
If the appliance has been delivered to your home in a horizontal position, stand it
upright and then wait 2 hours before plugging it in. A small amount of oil may have
flowed into the refrigeration circuit, and you must allow time for this to flow back
towards the motor before connecting the appliance. Failure to do so may damage
the appliance.
Carry out an initial cleaning operation (see the section on "Installing your appli-
ance") before connecting your appliance to the electrical supply. Disconnect your
appliance prior to performing any maintenance operation. Grasp the plug directly,
instead of pulling on the power cable.
"In case of damage, the supply cord must be replaced by the technical assistance
service or a person with a similar title, in order to prevent any risk."
Electrical connection
EN
Your appliance is compliant with European Directives CEE/73/23 (low voltage
directive), CEE/89/336 (electromagnetic compatibility) and CEE/96/57 (energy
efficiency) as well as their modifications.
Summary of Contents for CE3321X
Page 59: ...59 Notes EN ...
