EN-9
Listening to the FM Radio
Tuning in a Station
1 Press the
FUNCTION
button to select the
TUNER source.
2 Press and hold the
/
buttons(till
the digital display moves ), then release
the button, the frequency changes down
or up automatically until a station is
found.
3 Repeat steps 2-3 to tune to more stations.
Note:
- The unit will automatically switch the
Stereo or MONO channels to receive the
best FM effects.
Presetting Stations
You can preset up to 20 FM stations.
Program radio stations automatically
Press and hold the
M
/
Clock
button
for a few seconds to activate automatic
programming. All available stations are
programmed in the order of waveband
reception strength.
- The first programed radio station is
played automatically.
Note:
- If the system is unplugged or if a power
failure occurs, the preset stations will not
be erased.
Tune to a preset radio station
Press the
/
buttons to skip to
previous/next preset radio station.
Troubleshooting
To keep the warranty valid, never try to repair
the system yourself. If you encounter problems
when using this unit, check the following points
before requesting service.
No power
- Ensure that the AC cord of the apparatus
is connected properly.
- Ensure that there is power at the AC
outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Before you press any function button,
first select the correct source.
- Reduce the distance between the
remote control and the unit.
- Insert the battery with its polarities (+/-)
aligned as indicated.
- Replace the battery.
- Aim the remote control directly at the
sensor on the front of the unit.
Poor radio reception
- Increase the distance between the unit
and your NFC compatible bluetooth
device .
Clock setting erased
- Power has been interrupted or the
power cord has been disconnected.
- Reset the clock.
Using iPhone to play music
- When the iPhone is playing music
through the Dock, the iPhone may not
receive an incoming call signal due to
poor reception signal.
No Response From the Unit
- Disconnect and reconnect the AC power
plug, then turn on the unit again.
Downloaded from www.vandenborre.be
