66
EN
7 / INCIDENTS THAT MAY OCCUR
Problems:
Possible causes / Remedies:
A puddle of water forms around the
machine:
Caution:
First remove the plug or cut off the
relevant fuse and close the water intake valve.
During operation of the appliance, the constant level
check prevents water from overflowing. If water comes
out of the machine in spite of this, it is possible that:
- the emptying cross-piece is incorrectly positioned in
the discharge pipe.
- the connections between the water supply hose and
valve and the machine are not tight: check the pre-
sence of seals as well as tightening of connections.
-
NB:
excess foam may have caused overflow: in this
case (slight leak), try to re-program a supervised
cycle with a smaller amount of detergent. If the leak
reoccurs, contact the After-Sales Service.
The machine does not empty:
- you have programmed "Full tank stop".
- the drainage pump or filter are blocked: clean these
parts.
- the discharge pipe is bent or flattened.
The lid does not open:
- the program is not yet finished: the lid remains locked
for the duration of the program, and for as long as
the temperature remains too high (this may take a
few minutes).
Important:
Generally speaking, and regardless of the anomaly observed, the machine should be stop-
ped, the power cord disconnected and the water intake valve closed.
