-5-
Base Stand Assembly Instruction
Base Stand Assembly Instruction
Hanging the TV set on the wall
Remove the stand as one piece by reversing the fixing procedure described above.
You can refit the screws to the stand for safe keeping, but tighten them only slightly.
The wall fixing bracket should be 100 mm x 100 mm VESA approved
FIXING SCREWS
2x4mmx 5mm (TOP HOLES)
2x4mmx 5mm (BOTTOM HOLES)
Protect the screen and lay the TV flat on its face, on a stable table, with the stand foot clear of the
table edge.
To ensure a safe installation, please observe the following when hanging the television on a wall:
Warning: This operation requires two people.
Check that the wall can support the weight of the television set and a VESA-standard wall mount
assembly (not supplied).
Be sure to use only screws suitable for the material of the wall.
In case of any doubt please contact a qualified installer.
Beware of electrical cables, gas and water pipes in the wall.
Follow the instructions provided with the wall mount.
The set must be installed on a vertical wall.
Make sure that cables are placed so that there is no danger of tripping over them or damaging
them.
GB
1.
Place the TV with the display side down on a flat surface. Use a cloth to protect
.
the display Position the base stand onto the bottom of the neck of the stand.
2.
Attach the base stand to the neck of the stand by firmly tightening the
supplied screws.
Note:
The stand may come ready assembled, if so
attach it to the TV as instructed below.
Warning: Do not try to rotate the TV on the stand!
Make sure that the surface you want to put the set on
can support its weight.
Don't place the set on an unstable surface (such as a
moving shelf or the very edge of a unit).
Make sure that the stand base set does not overhang
the surface it is resting on.
Downloaded from www.vandenborre.be
