12
English
4. Initial use
Take the device out of the package and remove all the packaging material. Insert
two 1.5V AA batteries into the battery compartment of the device. Pay attention
to the correct polarity of the contacts. Close the battery compartment. The device
is ready for use.
General instructions
•
By pressing briefly on the ON/OFF/Mode button, the device is switched on in
the locked position. The laser flashes every 5 seconds.
•
The device can be switched off by pressing and holding the ON/OFF/Mode but
-
ton for approx. 2-3 seconds. It can only be switched off in the locked position.
•
When you slide the lock switch to the unlocked position, it switches on auto
-
matically. The device is now in self-levelling mode.
•
Press the ON/OFF/Mode button repeatedly to navigate through the available
modes.
•
Always ensure to slide the lock switch as far as it goes in the appropriate
position.
Self-levelling mode
•
This mode is activated when the lock switch of the device is in "unlocked" po
-
sition. The pendulum swings along with the laser, thus maintaining the balance
to show an ideal straight line.
Caution! If you tilt the device too far and a straight line cannot be guaranteed,
the laser starts to flash continuously.
1
ON/OFF/ Mode button
2
Lock switch / Power ON
3
Laser unit
4
Battery compartment
5
1/4 inches (") -20 fastening
