INSTALLATION INSTRUCTIONS
9002-2750v1.doc instructions V1 7-12-16
Page 2 of 5
JM
1.
Remove dash trim around screen/display in
dash.
2.
Remove the screws holding the screen into
the dash.
3.
Remove the screen from the dash.
4.
Check compatibility of screen/display on the
last page of this install guide.
5.
Remove the 6-pin connector from the
harness, if connected, then plug the
harness into the 6-pin connector on the
2750 module.
6.
The camera will have to be powered form
an accessory circuit in the vehicle. (If not
the interface will not see the video input
and not show the camera on the screen.)
7.
Disconnect the FCDIM/display harness on
the back of the display by pushing down
on the tab and pulling the “lever” back.
8.
Connect the T-harness into the FCDIM first
from the 2750.
