INSTALLATION INSTRUCTIONS
9002-2750v1.doc instructions V1 7-12-16
Page 3 of 5
JM
9.
Then connect the opposite end to the
vehicle harness, within 5 seconds turn the
key to the run/ignition position. (Do not
start the vehicle)
10.
Wait 2 minutes for programming to
complete. The FCDIM should reset twice.
11.
Test programming by placing the vehicle in
reverse. (Testing without a camera will
result in a “camera not available” message
and disable the camera input temporarily.
12.
If programming did not work, turn the
ignition on, unplug 6-pin harness from the
2750 for 5 seconds, and replace
programming will restart.
13.
Any camera with a RCA connector can be
used with this interface.
14.
Mount module to top of radio/cd case in
dash, behind screen.
