703739-1 Revision D Spider Glazier 2200 Operator's Manual Issue Date: 2019-Jan-25
Page 14 of 27
Flanged End
of Angle Brace
Square End through
Front Gantry uprights
Figure 7: Angle Brace Hardware
Nut
Washer
Bolt
Nut
Washer
Washer
Washer
Bolt
Square End of
Angle Brace
Figure 8: Angle Brace Blunt End Installed
c) Angle Brace Installation
Step 1:
Remove nuts from the screws in the square end of one
Angle Brace and insert the square end between the Front
Gantry uprights, as shown in Figure 7. LOOSELY
reinstall the nuts on the screws, as shown in Figure 8.
Step 2:
Remove the nuts and washers from the flanged end of
the Angle Brace. Rotate the flanged end of the Angle
Brace up to the Backspan and reinstall the nuts and
washers on the ends of the screws once they are through
the holes in the Backspan, as shown in Figure 9.
Step 3:
Repeat steps 1 and 2 for installing the other Angle
Brace on the Rear Gantry.
Step 4:
Tighten all nuts on the Angle Braces, the Backspan Top
Bolts, and both the vertical and horizontal screws on
the Backspan Support Brackets, as shown in Figure 9.
Avoid making the walls of the uprights bow in when
tightening screws.
Angle Brace Flanged End
Installed
Tighten these screws, but
do NOT make upright
walls bow in
.
Figure 9: Angle Brace Installed
