Brahler MSI8V CDSVAN, Operating Instructions Manual

Page: 12 / 28

MSI8V CDS VAN
12
Installation and starting up
The Compact Transmitter has an ex-works mains voltage setting of 90 - 250 Volts by 50 – 60 Hz. If there
is another voltage range you must not connect this equipment. In connecting the system, special attention
is to be paid to ensure that all cables are installed in cable ducts or that they are fixed by cable clamps or
adhesive tape in such a way that there is no danger of somebody tripping over them.
Termination LINK
Termination of the LINK socket via DIP switch:
ON: LINK socket not used (open)
OFF: LINK socket connected with another Compact Transmitter MSI8V
Connecting the VAN-IN socket
RJ45 for the connection to the CDSVAN-PC (transmission of the channels)
The input is balanced via AF transformer.
Connecting the VAN-LINK socket
Within a 16 channel system (1+15) the LINK socket can be used to transmit the channels
8 – 15 to the next MSI8V.
In this case the RF-Link socket (next page) also should be connected between the 2 MSI8V.
Connecting LINE-OUT sockets
8 XLR LINE-OUT connector (male):
All eight channels fed into the MSI8V from
the CDSVAN system via CAT5 are
available at these connectors, e.g. for
audio distribution or recording purposes.