Brady PAM 3000, Operator'S Manual

Page: 37 / 87

37 Printer-Applicator-System PAM 3000
10 Setup
Using the setup mode, the configuration of the PAM 3000 may be customized to suit specific
requirements. Initial setup should be performed when operating the printer for the first time.
Changes which become necessary to process different print jobs, e.g. when different
materials are used, can mostly be accomplished by changing the software settings.
Start of Setup Mode
This mode is initiated by either simultaneously pressing down the key and the key
when switching on the printer and keep them pressed until the system test is completed, or in
ONLINE mode, press the same two keys down for at least 5 seconds.
Starting the setup mode, the display shows "SETUP" for about one second, followed by
"Country" which represents the first of the parameters to select from. Depending on the
selection, the setup parameters and their settings will be shown. The list of parameters is
brought up in a row and may be run through repeatedly.
Each time a parameter setting has been changed, there will be a request for confirmation.
There will not be a general request before leaving the setup mode.
Leaving the Setup Mode
The setup mode can be left at any point by pressing the key. The confirmed parameters
will be saved.
If an already confirmed setting is not desired any more, switch off the printer during the setup
mode to cancel changes.
Restore the Default Setting
To return to the original factory default settings, press all three keys, the key, the key,
and the key simultaneously while switching on the printer and keep them pressed down
until the display shows "--- RESTORE ---".
Function Keys in System Mode SETUP
ONL key Stores the chosen and confirmed settings of the setup-parameters and
completes the SETUP mode.
(i.e. switch into ONLINE mode (LED ONL on)
FF key Skips to next setup parameter.
Reduces numerical setup values.
CAN key Skips to previous setup parameter.
Increases numerical setup values.
PSE key Confirms selected settings for parameters.