7
User Manual
Safety Instructions
•
Disconnect the printer from the electrical outlet before mounting or removing the cutter.
•
The cutter may only be operated when it is mounted on the printer.
•
Risk of injury, particularly during maintenance, the cutter blades are sharp.
•
Work going beyond this may only be performed by trained personnel or service technicians.
•
Unauthorized interference with electronic modules or their software can cause malfunctions. Other unauthorized
work on or modifications to the device can also endanger operational safety.
•
Always have service work done in a qualified workshop, where the personnel have the technical knowledge and
tools required to do the necessary work.
•
Warning stickers must not be removed, as then you and other people cannot be aware of dangers and may be
injured.
Danger!
Danger to life and limb from power supply.
Do not open the device casing.
3.4
Environment
Obsolete devices contain valuable recyclable materials that should be sent for recycling.
Send to suitable collection points, separately from residual waste.
The modular construction of the device enables it to be easily disassembled into its component parts.
Send the parts for recycling.
Take the electronic circuit boards to public waste disposal centers or to the distributor.
3.5
Technical Data
NG Guillotine Cutter
Technical data
Standard
Heavy Duty
for printer type
i7100
i7100
Material width
up to mm
120
114
120
114
weight
cardboard
up to g/m²
200
300
thickness
up to mm
1,1
1,5
Cutting length
from mm
10
10
Gap height
up to mm
2,5
2,5
Cut frequency
about cuts/min.
120
60
Cutter Tray for
Cutting length
up to mm
100
100
Monitoring
End position of the blade not reached
Blade is swung off
Blade cover removed
!
Attention!
The minimum cut length is depending on the media, in particular its adhesive characteristics.
Perform preliminary tests. Test the media too, if the media is very hard, very flexible or very thin.