19
i5100 Configuration Manual
6
Configuration
6.1.2
Labels
Start menu.
Select
Setup > Labels.
Parameter
Meaning
Default
Label sensor
Method for detecting the starting end of the label.
Gap Sensor
: Detection using changes in the transparency between the
label and label gap.
Bottom-Reflect
: Detection using reflex marks on the bottom of the medium.
Continuous media
: Checking the existence of media only.
Gap sensor
Extrapolate labels
The positions of the labels which are between the label sensor and the
printhead are calculated from the first label recognized by the sensor
and the programmed label distance. That way those labels can be
printed although the printhead previously was open.
Off
Table 6
Parameters of the
Setup > Labels
menu
6.1.3
Ribbon
Start menu.
Select
Setup > Ribbon.
Parameter
Meaning
Default
Transfer print
On
: Sensor for monitoring the transfer ribbon is activated.
Off
: Sensor for monitoring the transfer ribbon is not activated.
The setting can be overwritten for each print job via software. The basic
setting is not changed by this.
On
Warn level ribbon
Threshold diameter (32–74 mm) of the ribbon supply roll, if the value is
undershot the "ribbon low" message will be activated
Off
Pause on warning
The print job will be interrupted when the "ribbon low" message appears
Off
Monitor ink side
Setting of the ribbon unwinding direction
The print job will be interrupted when the wrong ribbon winding direction
has been detected. The error message "Ribbon ink side" appears.
Off
Table 7
Parameters of the
Setup > Ribbon
menu
