BradyJet J4000 User Manual
19
Adjusting Print Alignment
IMPORTANT!
Before adjusting any values, perform a test print to see how close you are to
alignment. The on screen graphic is the same as the print, which makes it easier to
adjust these values.
Three items can be adjusted here:
Cut Position
This value adjusts the position of the last label printed after it has been presented for tear
off. This only applies if the output mode is set to “Present the label.”
•
Add to the current value to move the tear point closer to the printer.
•
Subtract from the current value to move the tear point away from the printer.
The value is automatically saved as soon as you set it.
Left Margin Offset
This value moves the printed label left or right.
•
Add to the current value to move the printed label to the right.
•
Subtract from the current value to move the printed label to the left.
IMPORTANT!
Before adjusting this value make sure the label supply is properly loaded so that
there is no gap between the edge of the liner and the fixed throat guide. Any gap at
this point will greatly affect the left margin offset value needed to align the label.
Also, if you adjust the value with improperly loaded label supply you will have to
adjust it again if you load the label supply correctly the next time.
Summary of Contents for BradyJet J4000
Page 1: ...User Manual...
