Brady BBP11-34L, User Manual

Page: 26 / 33

22
BPP11 User Manual
After initialization, printer configuration will be restored to defaults as shown in the table.
Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor
To set Black Mark Sensor:
1. Turn off the power switch.
2. Hold the
Feed button down, then turn the power switch ON .
3. Release the ONbutton when LED turns green/amber after 5 green blinks. (Any
green/amber will do during the 5 blinks).
The LED color changes as follows:
• Amber Æ Red (5 blinks) Æ Amber (5 blinks) Æ Green (5 blinks) Æ
Green/Amber (5 blinks) Æ Red/Amber (5 blinks) Æ Solid Green
Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
To set Gap Sensor:
1. Turn off the power switch.
2. Hold the
Feed button down, then turn the power switch ON .
3. Release the button when LED turns red/amber after 5 green/amber blinks (any time
during the 5 blinks).
The LED color changes as follows:
• Amber Æ Red (5 blinks) Æ Amber (5 blinks) Æ Green (5 blinks) Æ
Green/Amber (5 blinks) Æ Red/Amber (5 blinks) Æ Solid Green
Parameter Default setting
Speed 127 mm/sec (5 ips) (203DPI)
76 mm/sec (3 ips) (300DPI)
Density 8
Label Width 4” (101.5 mm)
Label Height 4” (101.5 mm)
Sensor Type Gap sensor
Gap Setting 0.12” (3.0 mm)
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Tear Mode On
Peel off Mode Off
Cutter Mode Off
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
IP Address DHCP