TouchTime
®
Installation
2
3/1/2013
Bradley
• 215-1378 Rev. G; ECN 13-10-005
To help prevent electrical damage to the unit, Bradley recommends the use of surge protection. The type of
surge protection required and its usage is the responsibility of the installer/electrician.
Supplies Required
• 110 VAC power source for 24 VAC Class II transformer
• 110/24 VAC Class II transformer (available from Bradley as an option)
• (3) wire nuts to connect power cord leads to transformer wires
Install the 24 VAC Class II transformer in a remote location a safe distance from the area where the
security fixture is to be used.
(See chart on page 3 for
part number identification)
Mounting Bracket*
Nut
(161-080)
TouchTime Sensor
®
Escutcheon
(150-099)
Spring
(135-058)
Standard
Push Button
w/Magnet
(S08-311, COLD
S08-312, HOT
S08-313, FLUSH)
Ligature Resistant
Push Button
(S08-396)
Security Fixture
B
Insert the push button and spring
into the escutcheon, then insert
the escutcheon into through the
hole in the front of the fixture.
C
Thread the sensor through the mounting bracket and
the fixture onto the escutcheon, and secure the valve
to the fixture by turning nut 1/4 turn past finger-tight).
NOTE: Use bracket part no. 140-958 for 1-5/8"
diameter hole (e.g., COMBI 5500). Use bracket
part no. 140-627 for all square-hole applications.
D
Connect the black and brown power cord leads to the
wire on the transformer with wire nuts (supplied by
installer). Turn on the water supply and check for leaking.
Turn on the 24 VAC power and press the TouchTime
®
push button several times to purge air from lines.
1
Installation
A
Apply 100% silicone caulk to escutcheon
backside prior to installation to ensure a
water tight seal. Wipe excess caulk from
front side of escutcheon and panel.
