Installation
TouchTime
®
Bradley • 215-1378 Rev. G; ECN 13-10-005
3/1/2013
3
TOUCHTIME
®
APPLICATION
WIRE COLORS
SPADE CONNECTORS
PART NO.
4-second cycle from release of push button
Red & Gray
two female
S83-131A
15-second cycle from release of push button
Green & Gray
two female
S83-131B
30-second cycle from release of push button
Orange & Gray
two female
S83-131D
60-second cycle from release of push button
White & Gray
two female
S83-131C
180-second cycle from release of push button
Blue & Gray
two female
S83-131J
SOLENOID VALVE
SOLENOID VALVE
BROWN WIRE
BLACK WIRE
BLACK WIRE
BROWN WIRE
TOUCHTIME SWITCH
®
OUTPUT WIRES
(see chart below for wire
color descriptions)
OUTPUT WIRES
(see chart below for wire
color descriptions)
TOUCHTIME SWITCH
®
BLACK
RED
RED
YELLOW
TAPE/WIRE NUT
(supplied by installer)
{
To
Customer
120v supply
SOLENOID VALVE
BLACK WIRE
BROWN WIRE
OUTPUT WIRES
(see chart below for wire
color descriptions)
TOUCHTIME SWITCH
®
TRANSFORMER
BLACK
RED
RED
YELLOW
TAPE/WIRE NUT
(supplied by installer)
{
To
Customer
120v supply
TRANSFORMER
(2) FEMALE
CONNECTORS
Transformer may be hard-wired (as shown)
or plug-in type.
TouchTime
®
Wiring Diagram
Wiring for
Single-Solenoid
Fixture
Wiring for
Double-Solenoid or
Triple-Solenoid Fixture
(double is shown, triple is similar)
The push button has been factory-preset to provide activation and further adjustment should not be required.
However, if adjustment is necessary, loosen the nut on the TouchTime
®
sensor and move the sensor in or
out until activation has been achieved. Lock the nut in place 1/4 turn past finger-tight.
