Installation
TDB3104, WF3204
Bradley
• 215-1332 Rev. V; ECN 12-00-004
1/15/2013
9
3
Installing Drain Spud in Bowl
A
Secure drain spud with lock nut and washers.
A
Connect supply stops onto stub-outs.
B
Using a sharp knife, cut tubing squarely and
remove any burrs. Do not pinch or crush end
of tubing.
C
Loosen nut on fitting. Moisten end of tube
and push into fitting until it is firmly seated.
Tighten nut to secure tube to fitting (make
sure nut is securely tightened).
Seal between drain spud and drain hole with
plumber’s putty (supplied by installer).
Strainer and Spud
Bowl
Apply Plumber's Putty Here
Locknut
Drain Pre-Pack
(S45-273)
Fiber Washer
4
Connect Supply Stops, Sprayhead Supply Tubing and P-Trap
D
If connector leaks, reseat tubing. If leaking
persists, replace the male connector, or call
your bradley representative for assistance.
E
Connect p-trap (supplied by installer) to
tailpiece and drain outlet.
Tubing
Nut
Male 3/8"
Tube
Connector
(145-105)
Sprayhead
Tubing
Flush supply lines before making connections.
Do not use pipe sealant on compression fittings.
