3
Installation
S19-130F
Bradley Corporation •
215-152CO Rev. P; ECN 08-512
9/11/08
Installation
Supplies Required:
• Teflon tape and pipe sealant
• Piping to 1" NPT water supply inlet
• Adequate supply pipe supports
• Appropriate hardware to mount pulley to wall
• Minimum 4" (102 mm) drain to accommodate
30 gallons (115 liters) per minute discharge for
shower waste
• Sign-mounting hardware
Step 1: Assemble components
1. Assemble components as shown on page 4.
• Apply pipe sealant or tape (by installer) to
all male-threaded pipe joints.
• Bottom edge of showerhead should be 7'-
0" (2134 mm) from the floor.
Step 2: Connect water supply
IMPORTANT: Do not rely on Bradley’s
Drench Shower to support supply
piping.
1. Connect water supply piping to 1" NPT inlet
on unit (piping supplied by installer). Provide
adequate supports (supplied by installer)
for supply pipe using pipe hangers or other
means.
2. Mount the pulley and the eye screw to the
wall (pulley hardware supplied by installer).
3. Secure one end of the nylon cord to the “S”
hook on the eyewash valve handle. Feed the
cord through the pulley and then secure it to
the eye screw.
4. Mount the safety sign to the wall using sign-
mounting hardware supplied by installer.
5. Open water supply lines. Test for leaks and
adequate water flow.
4"
(102mm)
8.7"
(221mm)
Ø 3.
1"
(78.7mm)
24"
(610mm)
7'-0"
(2134mm)
Suggested
Height to
Floor
3'-0"
(914mm)
to Floor