Express® Deck Lavatory System EXD Series
Installation Instructions - For Service Only
EXD-3/WH97
7
Bradley Corporation •
215-1278 Rev. C; EN 03-817
6/8/04
Installation Instructions
continued . . .
Step 4: Connecting supply and drain
1. FOR HOT AND COLD SUPPLY: Connect the Vernatherm™ Thermostatic Mixing Valve as
shown in Figure 5a.
NOTE: The red marking on Vernatherm™ Mixing Valve indicates hot water supply inlet.
FOR SINGLE TEMPERED SUPPLY: Attach the stop/check/strainer to the 1/2" tempered supply
line. Connect the stop/check/strainer to the flexible supply hose (see Figure 5b).
FOR INFRARED FAUCET OPTION ONLY: Attach the stop/check/strainer to the 1/2" tempered
supply line. Connect the stop/check/strainer to the solenoid valves with the flexible supply hose
(see Figure 5b).
2. Install the two drain plugs in the two holes in the bottom of the bowl (see Figure 6).
3. Beneath the bowl, install the 1/4" rubber washers onto the drain plugs, and thread the waste tee
to the drain plugs.
4. Assemble the P-trap by connecting the 1-1/2" tubular pipe to the waste tee and to the 1-1/2"
drain pipe stubbed out of the wall.
5. Install the strainer on the drain plug opening inside the bowl, and push the strainer firmly into
place.
#8 SCREW
BOWL
DRAIN
PLUG
PLUG
RUBBER
WASHER
WASTE SHOE
WASTE TEE
Figure 6
Figure 5b
7-5/8"
(194mm)
1/2"-14 NPT
SUPPLIED BY
INSTALLER
THERMOSTATIC
MIXING VALVE
(S01-116)
COLD SUPPLY
STOP/STRAINER
CHECK VALVE
(S60-003)
TAILPIECE (129-007)
NUT (110-005)
WASHER (124-001AF)
HOT SUPPLY
Figure 5a
