2
9/28/2017
Bradley •
215-1595 Rev. E; ECN 17-00-014
S93-572, S93-573, S93-574
Installation
Supplies Required by Installer
• (8) #10 diameter bolts with washers and (8) wall anchors appropriate for your installation
• (3) 1/4" diameter bolts with washer and (3) wall anchors appropriate for your installation
• Wall reinforcement (if required)
• 1/2" nominal copper tubing for hot and cold water supply pipes stubbed 1" out of wall
• 1-1/2" NPT drain pipe stubbed 1" out of wall
• Pipe sealant and plumber’s putty
• For TT and IR Options
• 110 VAC power source (110VAC/12VDC plug-in adapter supplied)
• 110 VAC GFI outlet for transformer
• OPTIONAL: Bradley recommends installing an electrical cut-off switch to the unit . This feature
prevents accidental water delivery during regular maintenance and service .
WARNING
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
Hardware supplied by installer must be appropriate for wall construction. Wall anchors used must have a
minimum pull-out rating of 1,000 lbs.
CAUTION
Water supply requires a flowing pressure of at least 20 psi, but no greater than 80 psi.
The AccuZone
®
Infrared and TouchTime control must be connected with a 12VDC plug in adapter.
Connections to 110 VAC can cause personal injury and will result in damage to the electronics.
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file this
manual with the owner or maintenance department.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties may be found under "Products" on our website at www.bradleycorp.com.
