Bradford BALBOA M3, Installation & Operation Manual

Page: 31 / 50

Residential Spa
pg. 31
File: RES_Hottub_manual_021116
Testing Your Spa Set Up
Diagnostic Messages
Message
Meaning:
No message on display. Power has been cut off to the spa.
Action Required: The control panel will be disabled until power returns.
Spa settings will be preserved for 30 days with a battery backup.
Meaning:
“Overheat” - The spa has shut down. Either the spa water has reached 112°F
or the highlimit sensor has detected 118°F at the heater.
Action Required: DO NOT ENTER THE WATER. Remove the spa cover and allow water to
cool. At 110°F, the spa should automatically reset. If spa does not reset, shut off the
power to the spa and call your dealer or service organization.
Meaning:
“Flow” (Flashing) - Flow of water is inhibited.
Action Required: Check and open flow valves. Check for correct water level. Clean filter.
Meaning:
“Flow” (Not flashing) - A pressure switch has malfunctioned.
Action Required: Contact dealer or service organization.
Meaning:
“Cool” - Water temperature is 20°F or more below the temperature you last set.
Action Required: No action required. Spa is functioning properly.
Meaning:
“Ice” - Potential freeze condition is detected.
Action Required: No action required. The pump will automatically activate regardless
of spa status.
Meaning:
“Sensor 1” - Spa is shut down. High-limit sensor is not working.
Action Required: Contact your dealer or service organization.
Meaning:
“Sensor 3” - Spa is shut down. Water temperature sensor is not working.
Action Required: Contact your dealer or service organization.
Warning! Shock Hazard! No User Serviceable Parts.
Do not attempt service of this control system. Contact your dealer or
service organization for assistance. Follow all owner’s manual power
connection instructions. Installation must be performed by a licensed
electrician and all grounding connections must be properly installed.