45
8. Install the ring gear over the planet carrier assem-
bly. The ring gear teeth must mesh with the planet
gears. Ensure that the end with the deepest splines
is installed over the planet carrier.
9. Install the output sun gear and thrust washer.
Center the thrust washer over the planet carrier so
that the primary planet carrier pilot can be installed
through it.
10. Install the primary planet carrier assembly into the
ring gear, meshing the planet gears with the ring
gear teeth. The hub end of the carrier faces down-
ward engaging the output sun gear teeth. Ensure
the pilot on the hub end installs through the thrust
washer.
11. Install the thrust bearing set onto the carrier. The
.063 in. (1.6 mm) thick thrust race installs against
the carrier, followed by the needle bearing and the
.092 in. (2.3 mm) thick thrust race.
12. Install the ring gear adapter, hub end facing up,
meshing the adapter with the ring gear teeth.
13. If necessary, install the bearing into the drum clo-
sure, ensuring that it is fully seated against the
shoulder in the bottom of the bore. Apply sealing
compound to the outside diameter of the oil seal.
Turn the spring side of the seal toward the bearing
and press the seal into bore by applying constant,
even pressure. The seal is fully installed when the
outer surface is located flush to the face of the clo-
sure.
14. Lubricate the o-ring and install in into the O.D.
groove of the drum closure. Lubricate the O.D. of
the closure and install it into the cable drum, with the
seal side facing up.
15. Install the primary sun gear, meshing with the plan-
et gear teeth.
