Picture 2
Picture 1
MVM MODIFICATION INSTRUCTIONS
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 2
Begin by using the Ball Pein Hammer to fl atten the bend area
shown in Picture 1. Use your vises fl at anvil area to pound the
mount fl at.
Locate the strait line notch between the four holes on the side
of the MVM. Place this line so it is horizontal with the jaws of
your vise. Tighten the vise and bend in one direction to allow the
notched area to snap clean apart. Note: You may have to pound
the edges of the two peices fl at a little bit. You have now created
part (A) and part (B). See picture 2 at left.
Place part (A) back into the vise. See picture 2 at left to see where
to bend a 90 degree right angle. Note: you may need to enlarge
the middle hole to accomodate a small plastic pin. You can do this
with a small fi le. Take a small fi le and clean up any rough edges if
needed. Black paint or marker can be used to touch up any areas
that show bare metal.
Return to step 2 on page 2 to continue installing the MVM.
5
6
7
The Bracketron MVM-45-05 mount is a modifi able mounting bracket. The illustrations on the left show how this mount should
look during and after the modifi cation steps in order to fi t the listed vehicles on the front page of this manual.
Many vehicle
applications may not require any modifi cations to the mount. If this is the case it will be noted below and there will be no steps
to follow on this page.
PLEASE NOTE
© Bracketron Inc, 2007 All rights reserved.
The information in this document is subject to change without notice. Bracketron Inc. assumes no responsibility for any errors that may appear in this document nor
do we assume any liability in connection with its use. This supersedes and voids all previous literature. Please contact the sales department for additional information.
Bracketron Inc will not be responsible or liable for damage to vehicles in the installation and or removal of this Bracketron Inc mount. Bracketron Inc will not be liable
for personal injuries or damage to property resulting from a motor vehicle accident and or improper installation of this Bracketron Inc mount.
Note:
Please see page 3 in this manual for PHS-
203 Ultra Slim Swivel Instructions.
Bracketron Inc
5249 West 73rd Street, Suite G, Edina, MN 55439
tel:
952-746-7775
fax:
1-800-660-1784
toll free:
1-866-237-4443
email:
web:
www.bracketron.com
Bend Mount
Picture 3
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
(A)
(B)
Flatten Mount Here
Bend 90 Degree Right Angle
Notch A Larger Hole
2.25
(A)
(B)
