IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers
seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic
parts of a vehicles dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED:
MVM-15-05 Mount, 3- #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel, and Hardware
TOOLS NEEDED FOR MVM MODIFICATION
(
if required
)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
Fiskars 8511 Craft Hand Drill (recommended)
T20 and T25 torx drivers
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Open the cup holder and remove 2 rubber plugs with a hook pick. Remove
the 2 T20 torx scews and remove the cup holder. Open the ash tray and
remove the rubber plug and remove the T20 torx screw. With a dash removal
tool remove the cover that it around the cigarette lighter and remove the T20
torx behind it.
Pull the ashtray panel out, you do not have to unplug it. Unsnap the heaer
controls from the radio. Remove 4 T25 torx screws holding in the radio. Pull
radio out and down, you do not have to unplug the radio
Attach the MVM to the dash as shown with the supplied phillips screws.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
5
4
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
