30
Moto3 User Manual
Warning
High pressure braking is used in the disk brake system. For safety, replace oil tubes
and brake oil at the same time.
Chain adjustment
Check for wear loss, tightness and lubricating performance of chain.
1. Stand motorcycle upright with side stand, prod the chain up and down to check
droop within stipulated scope: 10-20mm.
2. Screw off nut on rear wheel axle and locking nut when adjustment is required,
adjust nut, adjust the chain tightness within the stipulated scope.
3. Slightly pour lubricating oil on chain.
Marks on left and right chain adjuster are at same position with scale mark on rear fork.
Warning
Excessively loosening the chain may lead to the chain dropping off and may cause an
accident. It may also seriously damage the engine.
Adjustment for brake switch
After the rear wheel has braked, make sure the brake light is working, in case it is not
lighting up, adjust regulating nut.
Check brake light when its switch connected, in case of no lighting, view brake lamp,
circuit, and brake switch, replace if required.
Caution
As for adjustment for switch of brake lamp, firstly, confirm free moving distance of brake
assy. in stipulated scope
1
2
1. Rear wheel axle
2. Chain adjuster with scale mark
Summary of Contents for Moto3
