BR-Automation Automation PC 820, User Manual, Page: 13 / 252

General information • Manual history
Ch
apte
r 1
Genera
l in
forma
tion
13 Automation PC 820 User's Manual V 1.00
Chapter 1 • General information
1. Manual history
Version Date Change
0.10 Preliminary 11.12.2008 - First version
0.20 Preliminary 23.01.2009 - The Chapters 4 "Software" and 7 "Maintenance / Servicing" were updated.
- Additional information about humidity specifications.
- Section "Installation" on page 75 updated.
- Section 3 "Glossary" on page 221 added
- Description of the temperature sensor positions moved to Chapter 2 "Technical data".
- Section 2.7 "Environmentally-friendly disposal" in chapter 1 "General information" added.
1.00 21.10.2009 - 2.4.2 "Power calculation with 5PC820.SX01-00" in Chapter 2 "Technical data" updated.
- Section 2 "CAN plugs (4-pin)" in chapter 6 "Accessories" added.
- 7.4 "Creating a bootable USB flash drive" updated.
- Photos of the power and reset button added.
- B&R CompactFlash card added.
- Technical data for Silicon Systems CFs revised.
- Section 2.2.3 "Temperature monitoring - Fan control" on page 38 added
- According updates regarding small changes made to interfaces and component positions for the
APC820.
- L2 cache of CPU board 5PC800.B945-00 corrected to 2 MB.
- Section 5.5 "Plug-in cards" on page 20 in chapter 2 "Technical data" added.
- Figure 13 "Block diagram - 5PC820.SX01-00" on page 42 updated.
- Interface descriptions added for revision A1 and later.
- PCIec plug-in cards 5ACPCC.ETH0-00 and 5ACPCC.MPL0-00 updated.
- RUN LED added to 2.6.11 "Status LEDs" on page 58.
- CPU board 5PC800.B945-04 added.
- Power supply with heat sink 5AC802.HS00-01 added.
- Chapter 5 "Standards and certifications" on page 173 added.
- ETH1 and ETH2 interfaces swapped.
- Technical data for the system unit 5PC820.SX1-00 completed.
- Data in section 2.2.2 "Temperature sensor position" on page 37 added.
- Figure 24 "Swivel range of the front cover" on page 78 changed.
- Section 2.3 "Humidity specifications" on page 39 changed.
- Figure "Block diagram - supply voltage" on page 40 changed.
- Section 2 "B&R Key Editor information" on page 219 added
- Section 2 "Upgrade information" on page 153 added
- Section 3 "Automation PC 820 with MS-DOS" on page 163 added
- Section 1.12 "Distribution of resources" on page 147 added
Table 1: Manual history