Bpt mitho+ Technical Manual Download Page 48

Page: 48 / 96

Technical Manual

WARNINGS

The information in this manual is covered by the rights of Bpt S.p.a. or its suppliers and may not be repro-
duced in any way, nor transmitted to others.
The information in this manual is subject to change without advance notice.
Bpt S.p.A. shall not be held liable for any errors which this document may contain.
No part of this manual may be reproduced in any mechanical or electronic form or means, for any use,
without the written permission of Bpt S.p.a.

ATTENTION

• After removing the packaging, check the condition of the unit.
• The packaging items (plastic bags, expanded polystyrene, etc.) must not be handled by children as they

may be dangerous.

• Carefully read the instructions before starting installation. Perform work as specified by the manufacturer.
• Before connecting the equipment, make sure that the rating plate data corresponds to that of the distribu-

tion network.

• An omnipolar switch, with contacts separated by at least 3mm, must be installed upstream on the equip-

ment, on the electric system of the building.

• The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable

use.

• Before performing any cleaning or maintenance operation, disconnect the equipment from the power

supply network by opening the system switch.

• In case of failure and/or malfunction of the device, detach it from the power supply and do not tamper

with it.

• Use original spare parts.
• Installation, programming, commissioning and maintenance of the product must only be performed by

qualified technicians who have been properly trained in compliance with current standards including
compliance with accident prevention.

• Operate in sufficiently lighted areas that are conducive to health and use tools, utensils and equipment

that are in good working order.

• Upon completion of installation, always check for correct operation of the unit and the system as a

whole.

•  Do not install the device outdoors or in areas where it is exposed to seepage or splashes of water.
•  Handle the device with care. It contains electronic parts that are fragile and sensitive to humidity.
•  The electronic cards can be seriously damaged by discharges of static electricity. If they are to be handled,

wear suitable clothing and anti-static footwear, or at least, ensure static electricity has been discharged by
touching with the fingertip a metallic surface connected to the earth system (e.g. the chassis of a house-
hold appliance).

•  Weld the joints between wires to prevent false alarms caused by oxidation of the wires.
•  The electrical system must comply with current standards in the country of installation.
•  Failure to comply with the above instructions may compromise the unit’s safety.
•  The installer must make sure that the information for the user, where applicable, is present on the devices.
•  Dispose of the unit in accordance with current standards.

ManTecnico_MithoPlus IT_GB 2484548 48

18-06-2008 11:49:33