OPERATION
Removing the SD memory card
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, take out the SD memory card.
12
Inserting the SD memory card
System Error Buzzer
A “Beep” “Beep” sound will occur and the BLUE & RED LED light will blink
simultaneously when there is a system error or SD card is not inserted.
[Check the SD memory card when this occurs. To solve the problem, initialize
the SD card or replace the SD card]
1. Make sure that the power cable is properly connected and turn on the car
power/ignition.
2. Blue LED & Red LED will turn on and slowly blink simultaneously. After
boot is complete, the Blue LED will remain on. Blue LED light means
VTR400 is now ready for the event recording or has started the Normal
recording (Continuous recording).
3. The normal recording (Continuous recording) will be automatically started,
if this is the record mode you have set with the PC viewer software.
4. The Event recording will be started automatically by Motion detection,
Alarm1, Alarm 2, Alarm 3, and/or by the G-sensor level and will begin with
one short “Beep” sound.
5. The Emergency recording can be started by pressing the [PANIC] button.
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, insert the SD memory card.
Always insert memory card when
power is OFF.
Summary of Contents for VTR400
Page 2: ......
