7
、
THE PROCEDURE OF SEALING THE WALL
8
、
INSTALLATION OF CONTROL VALVE
6
、
WATER TESTING AND SEALING TESTING
5
、
PIPE CONNECTION
9
、
SHOWER SETS INSTALLATION / HANDLE SHOWER INSTALLATION
11. CLEARANCE AND MAINTENANCE
10
、
PRODUCT REPARATION
1. Please drill the holes on the wall for the main body part, hot and cold water inlet pipes as
well as shower arm connection pipes according to the basic product dimension drawing as
Below.
2. Please make hot and cold water inlet pipe, the mixed water outlet pipe connect with control
valve, and tighten with the wrench.
1. After the pipe connection is completed, open the protective panel and cover, and then open
the cartridge, flush the pipeline; then close the cartridge to check the pressure resistance
and sealing performance of the pipeline, make sure there are no leakage.
2. Block each outlet pipe with a stopper then open the cartridge to check if the pipe joint is
well-sealed and the pipe condition under pressure to ensure no leakage.
Testing Purpose: Flush the impurities and sludge in the pipeline to avoid clogging and affect
the effluent functions.
Use a parallel ruler to measure the flatness of the valve and the vertical wall surface. If the
wall surface is not flat, it should be patched to ensure the valve and vertical wall angle meets
at nearly ideal angle of 90, then lay the tile decoration.
1. Take off the protective panel and cover.
2. The decorative panel and the handle are connected to the control valve as shown below
sequence.
3. According to the figure below, please correctly adjust the direction of water separator
Handle.
If the cartridge is worn out which cause leakage, please turn off the water source. Remove the
handle, panel, and decorative cover in sequence, remove the gland with a wrench, then take
out the cartridge and copper sleeve. Repair or replace the new cartridge, then install it again in
sequence.
In order to keep the faucet appearance smooth and good performance, please follow the below
steps to clean and maintain the faucet.
1. Clean with water and dry with a soft cotton cloth.
2. Use a mild liquid and a colorless glass cleaner to remove surface dirt and scale,
also you can use the cleaner without grinding function.
3. Do not use detergents, polishing tools, abrasive cloth, paper towels or scrapers to
clean the faucet.
4. Do not use acid cleaners, insoluble granular detergents, soaps etc to clean the
Faucet.
SCREW IN
Cold
water
Hot
water
SHOWER
