13
SCHM-001
Rev 2
Model: S2601 & S2605 Chairs
Programming Instructions:
1. Read these instructions completely before you begin programming.
2. Using the motor controls, position the chair as desired.
3. Wait at least three (3) seconds and push and hold the save (S) button for
four (4) seconds. The system will issue a confirmation beep. Within two
(2) additional seconds, push the button of the desired position (i.e.
“1”,”2”,”3”). The system will issue a second confirmation beep. This will
automatically replace any pre-programmed position.
4. Reposition chair and recall that position to ensure that it has been
programmed correctly.
5. Repeat steps 2, 3, and 4 until all desired positions are programmed. You
can save up to three (3) positions.
6. HOME is a preset position that cannot be changed.
The programmed positions can be attained at any time and from any position.
General Operating Instructions:
1. Before operating chair, watch for any obstructions under chair.
Do not allow small children to play on, around, or underneath
chair or base.
Do not allow service animals on or underneath chair or base.
Any obstruction that may hinder normal movement of any part of
the chair should be cleared away before initializing any
positioning of the chair.
Check to be certain that all people are clear of the chair before
operating chair functions.
2. Chair should be turned OFF at main power switch (C1) any time it is not
being used.
Operating Instructions
Outlet for use with Boyd Light Accessory
Only and may not be repositioned.
Improper use could lead to injury or
equipment damage.
Foot Control
Save
Position 2
Position 3
Position 1
230V
Outlet
115V
Outlet
Outlet Location
