12
SCHM-001
Rev 2
Location:
Full size templates are available upon request for laying out location of chair and utilities (if required) prior to actual
installation.
Caution:
Base must be anchored to floor. Failure to do so may result in serious bodily injury to operator and/or patient and
could cause unwarranted product damage. Chairs not properly anchored do not meet warranty requirements.
1. Position chair as desired. Drill holes in floor through base plate mounting
holes. Anchor base to floor with four (4) anchors provided.
Caution:
To prevent possible injury or damage, do not drill through
carpeting. Cut away carpeting at anchor hole locations.
2. Make utility connections in floor in front of base (if required).
3. Ensure safety covers are in place and removable upholstery is secure.
Shifting may have occurred during handling or shipping.
4. Plug chair into approved A/C outlet. Refer to Serial Number Sticker for
required voltage.
5. Turn main power switch ON (C1) located on the electrical panel at the front
of base.
6. Perform initialization procedure. (see below)
7. Perform safety and operational check.
8. If chair does not operate correctly, see the “Troubleshooting” section of this
manual.
9. When chair is operating correctly, turn main power switch OFF (C1) until
chair is to be used.
10. Refer to “Upholstery removal and installation” for upholstery use.
Initialization Procedure
1. Run the back motor to its full down position.
2. Run the base motor to its full up position.
3. Run the tilt motor to its full tilt position.
4. Run the toe motor to its full up position.
5. Press and release HOME button and allow both motors to fully return to the patient exit position
(back full up, base full down, tilt up and toe down).
Chair is now initialized and ready for use.
Installation Instructions
Chair Installation
Model: S2601 & S2605
Home
Base Up
Hand
Control
Back Down
Tilt Back
Toe Up
Toe Up
Tilt Up
Back Down
Base Up
Home
Foot Control
Front View of Chair
A/C Input
to Chair
Main Power
Switch (C1)
Light Power
Switch (C2)
Back View of Chair
Hand Control
Serial Number
Sticker
Foot Control
4x Anchors
