BOXER BHL-225, Manual

Page: 22 / 48

6.7 OPERATING HYDRAULIC
SIDE SHIFT (BHES AND BHUS MODELS)
1 When operating any service on the
backhoe you must be in the operator’s seat,
with the seat belt on. Do not operate the unit
from the ground beside it.
2
Ensure all bystanders and
other machinery are well clear of the swing
and slide radius when testing and
operating the unit
3
When operating the side shift on
the relevant models ensure the boom is lifted
fully, the dipper arm is fully in and the bucket
is fully crowded back. It is also a good idea to
swing the boom around 10-15 Degrees in
the opposite direction to the slide movement.
This takes the load off the boom hitch plate
and will allow it to slide freely. If you slew
the boom in the same direction you are
about to slide it, the loading edge of the boom
hitch plate with catch and dig in when you attempt to slide it across, this will eventually wear out the slides or create holes
for the slide plate to catch in..
4
The stabilizer legs are to be on the ground at all times when operating the backhoe.
5 Before digging with the slide models ensure the hydraulic locks are engaged and locked into place. Do not attempt
to slide the frame with the locks engaged
6
Ensure the boom and slew safely pins are removed before use and are reinstalled after use.
Observe the following safety warnings when working with your new backhoe / tractor.
CAUTION
: Boom Carrier must be locked prior to operation.
CAUTION
: When using a backhoe, be aware of bucket and boom location at all times. When raising Boom And
Deeper Arm, material can spill onto non-target arrest causing injury or damage.
[21]